Installation Manual
H3C VG 10-40/10-41 Voice Gateway Chapter 4 Booting and Configuration
Chapter 4 Booting and Configuration
4.1 Booting
4.1.1 Setting up Configuration Environments
I. Connecting the VG to console terminal
As shown in Figure 4-1, connect the RJ-45 connector of the
console cable to the console port on the VG, and DB25 or DB9
connector to the serial port on a PC.
VG 10-40/ 10-41
VG 10-40/ 10-41
VG 10-40/ 10-41
Console port
Console port
Console port
Figure 4-1 Local configuration through the console port
II. Setting parameters of the console terminal
Step 1: Start the console terminal and set up a new connection.
If the configuration is performed through a PC, the terminal
emulation program (such as Terminal of Windows3.1 and
HyperTerminal of Windows95/98/NT) should be run on the PC for
setting up a new connection. As shown in Figure 4-2, enter a name for
the new connection and press <OK>.
RS232 s erial
RS232 s erial
RS232 s erial
C onsole port cable
C onsole port cable
C onsole port cable
4-1
port
port
port
T erminal PC
T erminal PC
T erminal PC