FLASHFORGE 3D PRINTER Hunter User Manual page 43

B．Post size setting:
Tip diameter: supports tip diameter, the smallest is 0.25mm, and the biggest is
1.00mm
Tip angle: the angles between tip slope and vertical direction, a smaller angles
makes a longer tip. The small angle is 1º ,the biggest angle is 60º .
Post diameter: the larger the diameter of supports the stronger it will be, the more
difficult to remove.
Base diameter: the diameter of bottom post, the highest is 3mm, the lowest is
0.25mm.
Base height: the height of the support at the bottom of the bold part, the highest
height is 5mm, the lowest height is 0.
C．Other setting：
Enable tip ball: tip call will increase contact area between supports and models,
the bigger the tip diameter is, the more solid the contacting with model will be,but
more difficult to remove.
Bottom support only: generate supports at the bottom of the model only.
Bottom thickness: used to judge which part of the bottom needs generating
supports. The thinnest is 0.1mm, the thickest is 150.0mm.
Exterior only: generate supports which can contact with build plate only.
Hunter User Guide | www.flashforge.com
43
0086-0579-82273989