FLASHFORGE 3D PRINTER Hunter User Manual page 47

5.2.11 File Menus
① New Project
Click [File]--[New Project] can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification, while click [No] will
abandon it. If click [Cancel] or close tool tip, then it will cancel the new project.
5-12
② Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
Click [File]--[Save Project] in the menu bar to save the file as a project file with the
".fpp" suffix, all models in the scene (include support) are independent. After
reloading the files, extruder configuration information and model position will be the
same as the configuration during saving.
Method 2:
Click on [File]--[Save as...] to save the model as project file .fpp or .stl and .obj.
For .stl and .boj, models are integrated as one (include support part). If load it again,
only the position of the model was saved, not included the printing parameters.
③ Preferences
Hunter User Guide | www.flashforge.com 0086-0579-82273989
47