Table of Contents
Advertisement
Chapter 3. Unpacking
This chapter will present you the whole unpacking procedure of Hunter 3D
printer.
(Note: Make sure you read the whole unpacking guide.)
1. （3-1）Put Hunter package on the clean, tidy workbench, using a knife to cut the
tape from the bottom.
（3-2）Set the Hunter upright, lay the white foam on the floor and lift the carton.
2.
（
）
3.
3-3
Remove the foam and accessory box from the top. You will find a
Start
Guide, an
After-Sales Service Card
Hunter User Guide | www.flashforge.com
3-1
3-2
and a
Spare Vat Film
17
Quick
inside.
0086-0579-82273989
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Hunter and is the answer not in the manual?
Questions and answers