FLASHFORGE 3D PRINTER Hunter User Manual page 32

1
3
2
4.4.3 Turn on the Hunter printer, Tap[Settings]—Tap[Z Move] on the
touch screen(Showed in the picture below), make sure the present
number on [Z Move] interface is Z:150.00MM, Otherwise do not do
the following leveling operation！Please contact Flashforge to set this
number back to Z:150.00MM in Hunter's factory mode under the
instructions of Flashforge engineers, then you can do the following
leveling operation.
Hunter User Guide | www.flashforge.com 0086-0579-82273989
32