Model Processing - FLASHFORGE 3D PRINTER Hunter User Manual

6. Tap [Print] and then tap the middle USB stick icon.
7. A list of file(s) will show up, press the file that you would like to print, then tap
[Yes].
8. The printer will now enter preheating phase and will start printing once it finishes
preheating.
Printing via Wi-Fi
After the printer and computer have connected WiFi (Please refer to 5.2.13 ), load
the Gcode file in FlashDLPrint, then tap [Print] icon to start printing.
Notice: Please close the cover in the process of printing. After update Hunter
firmware 1.1.2, hunter will support light engine protect function, which will extend
light engine's the usable life. Please follow the steps below to turn off the power: first
turn off the touch screen button, and then turn off power button in the back of Hunter.

6.3 Model Processing

(6-6)After finish printing, please put on gloves and open the light shield, hold the
build plate and unscrew the platform screw, take out the build plate from horizontal
direction carefully.
Attention: Please put on gloves during operation,
Carefuly pour the used photopolymer resin into a clean bottle, it can be recycled.
Photopolymer resin needs to be stored in a dark, dry and cool place.
6-6
Hunter User Guide | www.flashforge.com 0086-0579-82273989
56