FLASHFORGE 3D PRINTER Hunter User Manual page 49

Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcut Ctrl+Y.
③Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
④ Select All
By the following two methods, you could select all models in the scene.(When
models are too small to be seen or out of viewing scope, please click
[Scale] buttons to adjust the model.)
Method 1: Click [Edit]--[Select
Method 2: Press the shortcut Ctrl+A.
⑤ Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut
⑥ Delete
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut
⑦Auto Layout All
Click [Edit]--[Auto Layout All]
models will be placed automatically as automatic placement rule.
⑧ Repair Models
Click [Edit]--[Repair Models]
⑨ Supports
Click [Edit]--[Supports]
⑩Leading Hole:
Click [Edit]--[Leading Hole]
Hunter User Guide | www.flashforge.com
All].
Ctrl+D
Delete
after loading one or more than one models, all
to repair models.
to enter supports setting interface.
to add hole in the mode to let uncured resin out of
49
[Center] and
0086-0579-82273989