Update Firmware - FLASHFORGE 3D PRINTER Hunter User Manual

6.4 Update Firmware

Method 1：Update from USB stick
1. Insert the USB stick into the USB stick slot on the computer.
2. Empty the USB stick by either deleting or moving all the files in the USB stick.
3. Create a folder with the name dlp-ii under the USB stick's root directory.
4. Copy the three updating files to dlp-ii folder in the USB stick.
The three files are: dlp-ii-version-date.tar.gz、usb_updator、version , please contact
and acquire them from FlashForge or your reseller.
5. Flip the power switch on the back of printer to OFF position, insert the USB stick
(prepared above) into the USB stick slot on Hunter.
Flip the power switch on the back of printer to ON position, turn on the Hunter printer
by pressing the black button on the right of printer's touch screen, automatic updating
interface will show on touch screen.(Make sure power is not turned off during this
step！)
6. After update success, pull out the USB stick, Tap[OK], Hunter printer will reboot
automatically (Make sure power is not turned off during this step!), firmware
Hunter User Guide | www.flashforge.com 0086-0579-82273989
58