Table of Contents
Advertisement
4.4.4 Tap[Zero] on the Z Move interface(Showed in the picture
above),wait for build plate moving down into the resin vat and stop.
4.4.5 Manually press down and flatten the platform with the resin vat
(Do not use too much strength or push too hard！ ), meanwhile tighten
the screw which is loosened in previous step 4.4.1 with a 4mm
hexagon wrench. The screw is located on the right and above the
build plate, showed in the picture below:
Hunter User Guide | www.flashforge.com
0086-0579-82273989
33
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Hunter and is the answer not in the manual?
Questions and answers