FLASHFORGE 3D PRINTER Hunter User Manual page 46

④ Save as new: To custom the material type and remember this choice.
⑤ Remove: Clear the custom material type.
⑥ Layer height: To set the height of each layer while printing, the default value is
0.025mm, optional values are 0.05mm. Higher the value is, lower printing precision
and higher speed the model has, and vice versa.
●Exposure time
a. Base Time: To set expose time to solidify a layer of photopolymer resin.
b. Attach Time: To set the expose time that solidify the attached a layer of
photopolymer resin.
c. Gradual Time layers
d. Light Intensity: According to the sensitivity of light to adjust the light
intensity. Use FlashForge photopolymer resin need not any adjustment, default 100%.
 Raft: To choose whether print the raft.
 Size adjust
a. X adjust: According to the previous printing error to adjust the x-axis size.
b. Y adjust: According to the previous printing error to adjust the x-axis size.
c. Outline compensation: According to the size error of the previously printed.
 Infill
a. Fill Density: Fill rate.
b. Shell Thickness: To set the shell thickness value between 1mm to 10mm.
c. Infill Thickness: To set the infill thickness value between 0.5mm to 5mm.
 Others
To set the space between support and model.
Hunter User Guide | www.flashforge.com
46
0086-0579-82273989