Table of Contents
Advertisement
EN
Voercomputer—Feeding computer—Fütterungscomputer—ordinateur d'alimentation
7.5.1.2 Feed type
Click on submenu feed types and select one of the preconfigured feed types. The screen will be displayed as shown below.
Feed type:
Description:
Calibration transponder:
Max per visit %:
Assigned to dispenser:
Index
Hanskamp AgroTech B.V. (the Netherlands)
Feed type number.
Enter the name of the feed type.
This is the transponder number which can be used to calibrate this feed type. For further ex-
planation, see chapter 7.4.
Default 30%. Set the maximum amount of this feed type an animal should receive per
visit. This affects the minimum number of visits an animal needs to receive its full
feed ration every day. It may be necessary to adjust this for certain feed types.
SpiderPCB is set to 'In Milking Parlour', the Spider does not check this setting and the total
feed ration is distributed over the number of milking sessions.
This indicates whether this feed type has been assigned to a dispenser. This can be program-
med in the SpiderPCB configuration, see chapter 4.2.
www.hanskamp.nl/en
44 - 68
Spider
When a
Advertisement
Table of Contents
