Table of Contents
Advertisement
EN
Voercomputer—Feeding computer—Fütterungscomputer—ordinateur d'alimentation
7.3.5 Gate/motor control
The motors and gates can be controlled manually from here.
FEEDER "-"
Test:
Closing gate no.:
Test:
Auto:
On:
Off:
Disabled:
Front gate no.:
Test:
Auto:
On:
Off:
Disabled:
Note: the above functions only work when the switch on the L'port or T'port is set to "auto".
Select Auto (default) to close the closing gate automatically; the gate will close when feeding commences and open again once
the feeding process is complete.
7.3.6 Logging:
This screen displays extra information on the communication between the Server and the Client(s).
Index
Hanskamp AgroTech B.V. (the Netherlands)
The dispenser will complete a single rotation to test whether the dispenser still works
properly. A valve will be actuated for 10 seconds.
The exit number which the closing gate is connected to; these can be found in blocks of 3 at
the bottom of the Spider PCB.
Test the correct operation of the closing gate; the gate will be actuated for several seconds
and close.
If present, the closing gate will be automatically actuated and will close.
The closing gate will be actuated and will close.
The closing gate will remain open.
The closing gate is temporarily disabled.
The exit number which the T'port is connected to.
Note: this only applies to the FeedStation walk-through.
Test the correct operation of the closing gate.
If present, the front gate will be automatically actuated.
The front gate will be actuated and will close.
The front gate will remain closed.
The closing gate is temporarily disabled.
40 - 68
www.hanskamp.nl/en
Spider
Advertisement
Table of Contents
