Table of Contents
Advertisement
EN
Voercomputer—Feeding computer—Fütterungscomputer—ordinateur d'alimentation
4.2 Add and configurate SpiderPCB
−
Go to Maintenance and sign in using admin password, see chapter 7.5.2.1.
−
Then go to Settings>Configuration SpiderPCB. The next screen will open. Fig. 1.
−
Select the SpiderPCB (fig. 1) to be configured
−
Select 'Add', when there is'nt a PCB at your screen or an extra has to be added. Than the next screen will open (fig. 2).
Select the number of feeding stations you want to add, as well as the number of feed types per feeding station. Select the
motor type. Note: these are preconfigured settings and can be changed in the next screen. Once the selection has been made,
click Apply.
The screen will open as shown in figure 3. Configure your feeding station here.
When you click on 'Predefined Layout', you can choose from the most common formats
Change the address, description and settings if necessary.
Index
Hanskamp AgroTech B.V. (the Netherlands)
.
The screen will open as shown in figure 3.
21 - 68
www.hanskamp.nl/en
1
2
3
Spider
Advertisement
Table of Contents
