Relocation And Storage - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
1.

Relocation and Storage

Follow the steps below when you move or store this server.
1. Remove the media from the optical disk drive.
2. Power off the server (POWER LED goes off).
3. Unplug the power cord of the server from the power outlet.
4. Disconnect all the cables from the server.
5. Remove both CPU/IO modules and 4U frame.
6. Carry the removed CPU/IO modules and 4U frame separately.
16
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety Precautions .

Do not disassemble, repair, or alter the server.

Do not remove the lithium battery, NiMH, or Li-ion battery.

Disconnect the power plug before installing or removing the server.
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety Precautions.

Make sure to complete installation.

Do not get your fingers caught.

Be careful of handling internal components that may be at high
temperatures.

Note If the server needs to be relocated/stored due to a change in the floor layout to a great
extent, contact your service representative.

If the server has hard disk drives, move the server while being careful not to damage
the drive.

When storing the server, monitor the environmental conditions of the storage area
(temperature: 10C to 55C, humidity: 20% to 80%). (No dew condensation is
permitted)
Tips
Make backup copies of important data stored in the hard disk drive.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
WARNING
CAUTION
1. Relocation and Storage