NEC Express5800 Series Maintenance Manual page 109

Chapter 2 Configuring and Upgrading the System
<Modify the resolution>
Select a combination of resolution and refresh rate among the list shown by (3), enter the value in Modes
shown by (2).
Select the combination of the resolution that can be set by the value (1) in the above figure and refresh
rate from (3) in the SubSection as the same as (2) including the same value as (1), and delete "#" at the
left edge of the line of the combination of the resolution and refresh rate to be used (applied).
Add "#" to the left edge of the line (combination of the currently-used resolution and refresh rate) that
does not have "#" originally.
* Check that only 1 line does not have "#" for the combination of the resolution and refresh rate in the
same SubSection.
3. If the X Window System is started, select Logout from the system menu to quit X Window System.
4. The mode is switched to the console mode (CUI), start up the X Window System by entering "startx".
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
3. Configuring Video Mode
109