NEC Express5800 Series Maintenance Manual page 40

Chapter 1 Maintenance
Indications of the status LEDs when CPU/IO modules are duplicated
1
2
3
* The numbers in table above correspond to those shown in figure above.
DISK ACCESS LED (2) lights only when hard disk drive is accessed.
3. Start ft Server Utility.
# /opt/nec/esmpro_sa/bin/ESMftcutil
4. Select PCI Module and then the primary PCI module (*) from the ft server tree.
– Select PCI module (ID:10) when CPU/IO module 0 is primary module.
– Select PCI module (ID:11) when CPU/IO module 1 is a primary module.
5. Select Stop of Start/Stop
40
LED
PRIMARY LED
DISK ACCESS LED Blinking (Green)
LED
System FT LED
When you stop the operation of the primary PCI module, a failover occurs and the
Tips
secondary PCI module becomes the primary module.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
5. Checking the Duplicating Operation of Modules
Primary Secondary
On (Green) –
Blinking (Green)
System
On (Green)