NEC Express5800 Series Maintenance Manual page 105

Chapter 2 Configuring and Upgrading the System
5. Execute the following command to check that bond2 is configured in Slot 5 and Status of eth100100 and
eth110100 is DUPLEX.
# vndctl status
--Virtual Network Status—
BondingDevice Slot Status InetAddress
bond0
bond1
bond2
Slot RealDevice Status
1 Top eth100600 DUPLEX
bottom eth100600 DUPLEX
2 Top eth100601 DUPLEX
Bottom eth110601 DUPLEX
5 top eth100100 DUPLEX
bottom eth110100 DUPLEX
6 top -
bottom -
*1 Only BondingDevice being operated (ONLINE status) appears. (InetAddress of bond0 and bond1 is an
example of displaying.)
*2 All individual interfaces recognized by the system are displayed.
<Descriptions>
[Coupled interface]
BondingDevice
Slot
Status
InetAddress
RXErrors
TXErrors
Collisions
[Network interface]
Slot
RealDevice
Status
Interface Startup status of interface (UP/DOWN)
LinkState LAN cable connection status (LINK/NOLINK)
LinkSpeed
1 ONLINE 10.10.1.151
2 ONLINE 172.16.40.51
5 ONLINE 192.168.0.101
Coupled interface name
Number allocated by the vndctl command
Status of the coupled interface name
Status
ONLINE Online
OFFLINE Offline
BROKEN Failure in both systems, or disconnected
IP address
Error packet count (At receiving)
Error packet count (At sending)
Packet collision count
Number allocated by the vndctl command
Network interface name
Network interface status
Status Description
DUPLEX Duplicated normally.
SIMPLEX One-side communication
BROKEN Failure or disconnected
LAN communication speed [Mb/s-FD]
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
RXErrors TXErrors Collisions ------- (*1)
0 0 0
0 0 0
0 0 0
Interface LinkState LinkSpeed -------- (*2)
UP LINK 1000Mb/s-FD
UP LINK 1000Mb/s-FD
UP LINK 1000Mb/s-FD
UP LINK 1000Mb/s-FD
UP LINK 1000Mb/s-FD
UP LINK 1000Mb/s-FD
Description
2. Network Duplexing
105