NEC Express5800 Series Maintenance Manual page 45

Chapter 1 Maintenance
5. Start the CPU module stopped.
Select the stopped CPU module and select Start of Start/Stop.
Indications of status LEDs after completion of duplication
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
When the CPU module is started, Hardware diagnosis and then synchronization of
Tips
memory (memory copy) are performed, and the duplication process is completed.
Note that the system is paused temporarily for copying memory during memory
synchronization.
LED CPU/IO module 0 (Operating)
(Lights green when accessing the
LED
Important After duplication is completed, the System FT LED lights in green. Do not perform
the evaluation of start and stop unless the above process is completed.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
5. Checking the Duplicating Operation of Modules
CPU/IO module 1 (Operating)
On (Green)
Blinking (Green)
(Lights green when accessing the
disk drive)
System
On (Green)
–
Blinking (Green)
disk drive)
45