Quitting The Sas Configuration Utility - NEC Express5800 Series Maintenance Manual

Chapter 3 Useful Features
3.2

Quitting the SAS Configuration Utility

Take procedures below to quit the SAS/ Configuration utility.
1. Keep pressing the <Esc> key until the Adapter List menu appears.
2. From the menu, select either "Discard changes and reboot" or "Exit the Configuration Utility and Reboot",
and press Enter.
3. Start the BIOS Setup Utility according to 1.1 Starting SETUP in 1. System BIOS in this Chapter.
4. Select [UEFI] in the [Boot mode] under the [Boot] menu.
5. Select [Save Changes and Exit] in the [Save & Exit] menu, and restart the server.
Are you sure you want to exit?
Cancel Exit
Save changes and reboot.
Discard changes and reboot.
Exit the Configuration Utility and Reboot
Do not use the SAS Configuration utility to change the setting. If you mistakenly changed
Tips
the setting, you should select [Discard changes and reboot] before closing the utility.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
3. SAS Configuration Utility
201