Table of Contents
Advertisement
After every operation
"Fill water tank"
message
"Fill water tank?"
message
Automatic
calibration
After moving house
All manuals and user guides at all-guides.com
Empty the water tank after each use.
1. Pull the water tank out of the appliance slowly,
keeping it horizontal, so that no remaining water
can drip out of the valve.
2. Empty out the water.
3. Thoroughly dry the water tank in the appliance and
the seal in the tank cover.
If the water tank is empty, a signal sounds. "Fill water
tank" appears in the display. Operation is stopped.
1. Open the appliance door carefully. Steam will
escape.
2. Take out the water tank, fill to the mark and
reinsert.
3. Press the Start button.
This message appears if you set an operating mode
and the water tank is only half full.
If you think that the water in the water tank is sufficient
for the cooking procedure, you can restart the
appliance.
If not, fill the water tank to "max.", slide it back in and
start the appliance.
The boiling temperature of water depends on the air
pressure. During calibration, the appliance is set to
the pressure ratios at the place of installation. This
occurs automatically when steaming for the first time
at 100 ºC. This causes more steam to develop than
usual.
So that the appliance automatically adjusts itself to
the new location, you must reset the appliance to the
factory settings (see Section: Basic settings).
13
Advertisement
Table of Contents
