Table of Contents
Advertisement
Automatic calibration
The boiling temperature of water depends on the air pressure.
During calibration, the appliance is adapted to the pressure
conditions in the location where it is installed. This happens
automatically when you first use the appliance (see section:
First use). More steam develops than usual.
It is important that the appliance steams without interruption for
20 minutes at 100 °C. Do not open the appliance door during
this time.
If the appliance was not able to calibrate itself automatically (for
example, because the appliance door was opened), the
Your accessories
The accessories supplied with your appliance are suitable for
making many dishes. Ensure that you always insert the
accessories into the cooking compartment the right way round.
Accessories
Use only the accessories supplied with the product or available
from the after-sales service. They are specially designed for
your appliance.
Your appliance is equipped with the following accessories:
You can buy accessories from the after-sales service, from
specialist retailers or online.
Locking function
The accessories can be pulled out approximately halfway
before they lock in place. The locking function prevents the
accessories from tilting when they are pulled out.
The accessories must be inserted into the cooking
■
compartment the right way round for the tilt protection to
work properly.
Always insert the accessories fully into the cooking
■
compartment so that they do not touch the appliance door.
Note: Your appliance will include different accessories,
depending on the appliance equipment.
When inserting steam containers, make sure that the lug (a) is
at the back and is facing downwards.
Wire rack
For ovenware, cakes and ovenproof
dishes, and for roasting
Cooking container, perforated,
GN
Z
, 40 mm deep
for the steaming of whole fish or
large quantities of vegetables, for
juicing berries, etc.
Cooking container, solid, GN
40 mm deep
For catching dripping liquid when
steaming and for cooking rice,
pulses and cereals
calibration process is carried out again during the next cooking
operation.
After moving house
So that the appliance automatically adjusts itself to its new
location, you must reset the appliance to the factory settings
(see section: Basic settings) and repeat the initial start-up
process (see section: First use).
After a power cut
The appliance saves the calibration settings even in the event
of a power cut or disconnection from the mains. Recalibration
is not necessary.
When inserting the wire rack, check
that the lug (a) is pointing downwards
■
that the safety lug on the wire rack is at the back and facing
■
upwards.
Cooking compartment
The cooking compartment has four shelf positions. The shelf
positions are counted from the bottom up.
Z
,
Caution!
Do not place anything on the cooking compartment floor. Do
■
not cover it with aluminium foil. A build-up of heat could
damage the appliance.
The cooking compartment floor and the evaporator dish must
always be kept clear. Always place ovenware in a perforated
cooking container or on a wire rack.
Do not slide any accessories between the shelf positions, or
■
they may tip.
7
Advertisement
Table of Contents
