Setting The Exposure Time; Camera Output Format - Dalsa Piranha 3 Series User Manual

Piranha 3 User Manual

Setting the Exposure Time

i
Purpose:
Applies to Modes 2 and
Syntax:
8
Syntax Elements:
Notes:
Related Command s:
Example:

3.3 Camera Output Format

3.3.1 Setting the Camera Link Mode
Purpose:
Syntax:
Syntax Elements:
Notes:
Example:
Teledyne DALSA
All manuals and user guides at all-guides.com
Sets the camera's exposure time is µs. Camera must be operating in
mod e 2 or 8.
set f
i
Desired exposure time in µs. Allow able values are 3 to 3330µs.

To read the current line frequency, use the command
get set.

If you enter an invalid line rate frequency, an error message is
returned .
sem, ssf
set 400.5
Sets the camera's Camera Link con figuration, number of Camera
Link taps and d ata bit d epth. Refer to Table 12 for a d escription of
each Camera Link mod e.
clm m
m
Output mod e to use:
15: Med ium configuration, 4 taps, 8 bit output
16: Med ium configuration, 4 taps, 12 bit output
21: Full configuration, 8 taps, 8 bit output

To obtain the current d ata mod e, use the command
clm.

The bit patterns are d efined by the Camera Link Road map and
the Camera Link Stand ard .
clm 15
31
gcp
or
gcp get
or
03-032-10216-06