Revision History - Dalsa Piranha 3 Series User Manual

Piranha 3 User Manual

Revision History

Revision
Number
00
01
02
03
04
05
06
Teledyne DALSA
All manuals and user guides at all-guides.com
Change Description
RoHS camera p reliminary release.
CE and no-Pb stamps ad d ed to front cover.
New parameter (4) ad d ed to command Correction Calibrate PRNU (cpa), pages
25, 46, and 79.
Tw o new command s ad d ed : Set FPN Range (sfr), and Set PRNU Range (spr),
pages 47, 49, and 83.
Tooling hole d imensions ad d ed to mechanical d raw ing, section 4.1 page 63.
Piranha 3 square option ad d ed to mechanicals section, section 4.1 page 63. Also
ad d ed to the Mod els table, page 8, and to the EMC d eclaration, page 85.
-Labels for pow er and control/ d ata connectors upd ated on the mechanicals.
New labels read : "Pow er 12 - 15V DC" and "Control & Data 1."
-Revised allow able line rate values, page 30. 12k: 2500-23619Hz and 8k: 2500-
33855Hz.
- Reference to the camera w ith square bod y and heat sink (P3-87-12k40-01-00-R)
removed .
-Camera mod el names on cover revised to includ e all mod els.
-Input and output connectors figure, page 16, revised to includ e both camera
bod y mod els, slim and square.
-Revised mod el numbers ad d ed to mechanical interface d iagrams, page 63.
-Measurement units (mm) ad d ed to mechanical d iagrams.
N ote ad d ed to section 2.2.3 recommend ing a Camera Link cable no longer than
5 meters for lossless d ata transmission.
Camera mechanicals revised so that the sensor alignment is d one based on the
tooling holes in the camera's front plate. Mechanical illustration in the manuals
and d atasheets revised to show the new alignment. Teled yne DALSA log o and
information also ad d ed .
Appendix D
87
03-032-10216-06