Returning All Camera Settings With The Camera Parameter Screen - Dalsa Piranha 3 Series User Manual

Piranha 3 User Manual
3.6.6 Returning Camera Settings
Returning All Camera Settings with the Camera
Parameter Screen
The cam era param eter (gcp) screen retu rns all of the cam era's cu rrent settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
GCP Screen
GENERAL CAMERA SETTINGS
Camera Model No.:
Camera Serial No.:
Firmware Design Rev.:
CGI Version:
FPGA Design Rev.:
UART Baud Rate:
Exposure Mode:
SYNC Frequency:
Internal Exposure Time:
Video Mode:
Teledyne DALSA
All manuals and user guides at all-guides.com
gcp
P3-xx-xxxxx
xxxxxxxxx
xx-xx-xxxxx-xx
03-81-xxxxx-xx
xxx.xx
9600
2
5000 Hz
50 uSec
video
57
Desctiption
Camera mod el number.
Camera serial number.
Firmw are d esign revision
number.
CGI version. Part of FPGA
firmw are.
DSP d esign revision
number.
Serial communication
connection speed set w ith
sbr
the command . See
Setting Baud Rate on page
24 for d etails.
Current exposure mod e
sem
value set w ith the
command . See section
3.2.1 Exposure Mod e, Line
Rate and Exposure Time
for d etails.
Current line rate. Value is
ssf
set w ith the
command . See section
3.2.1 Exposure Mod e, Line
Rate and Exposure Time
for d etails.
Current exposure time
setting. Value is set w ith
set
the command . See
section 3.2.1 Exposure
Mod e, Line Rate and
Exposure Time for d etails.
Current vid eo mod e value
svm
set w ith the
command . See section
3.6.1 Generating a Test
Pattern for d etails.
03-032-10216-06