Setting The Line Rate - Dalsa Piranha 3 Series User Manual

30
Mode 7: Internally Programmable Line Rate, Maximum Exposure Time
In this m od e, the line rate is set internally w ith a m axim u m exposu re tim e.
Figure 11: Mode 7 Camera Timing
Internal Sync set
with
Mode 8: Maximum Line Rate, Programmable Exposure Time
In this m od e, the exposu re tim e is set internally w ith a m axim u m line rate.
Figure 12: Mode 8 Timing
CR=Charge Reset

Setting the Line Rate

i
Purpose:
Applies to Modes 2 and
7
Syntax:
Syntax Elements:
Notes:
Related Command s:
Example:
03-032-10216-06
All manuals and user guides at all-guides.com
Line Period
Exposure Time
Readout
ssf Command
EXSYNC Falling
Edge ignored
during readout
(Only Possible on
sot change)
Programmable Period
Readout CR Exposure Time
Frame Period
Sets the camera's line rate in Hz. Camera must be operating in
exposure mod e 2 or 7.
ssf f
i
Desired line rate in Hz. Allow able values are:
12k: 2500-23619 H z
8k: 2500-33855 H z

To read the current line frequency, use the command
get

If you enter an invalid line rate frequency, an error message is
returned .
sem, set
ssf 10000
Line Period
Exposure Time
Readout
Readout
ssf.
Piranha 3 User Manual
EXSYNC Falling
Edge ignored
during readout
Programmable Period
CR Exposure Time
Frame Period
gcp
or
Teledyne DALSA