Returning All Camera Settings With The Camera Parameter Screen - Dalsa Piranha3 User Manual

Piranha 3 User Manual
3.6.6 Returning Camera Settings
Returning All Camera Settings with the Camera Parameter
Screen
The camera parameter (gcp) screen returns all of the camera's current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
GCP Screen
GENERAL CAMERA SETTINGS
Camera Model No.:
Camera Serial No.:
Firmware Design Rev.:
CGI Version:
FPGA Design Rev.:
UART Baud Rate:
Exposure Mode:
SYNC Frequency:
Internal Exposure Time:
Video Mode:
DALSA
gcp
P3-xx-xxxxx
xxxxxxxxx
xx-xx-xxxxx-xx
03-81-xxxxx-xx
xxx.xx
9600
2
5000 Hz
50 uSec
video
57
Desctiption
Camera model number.
Camera serial number.
Firmware design revision
number.
CGI version. Part of FPGA
firmware.
DSP design revision
number.
Serial communication
connection speed set with
the command. See
sbr
Setting Baud Rate on page
24 for details.
Current exposure mode
value set with the
sem
command. See section
3.2.1 Exposure Mode, Line
Rate and Exposure Time
for details.
Current line rate. Value is
set with the
ssf
command. See section
3.2.1 Exposure Mode, Line
Rate and Exposure Time
for details.
Current exposure time
setting. Value is set with
the command. See
set
section 3.2.1 Exposure
Mode, Line Rate and
Exposure Time for details.
Current video mode value
set with the
svm
command. See section
3.6.1 Generating a Test
Pattern for details.
03-032-10216-02