Connect The Fibre Channel Cable; Configuring And Installing A Tabletop Tape Drive; Figure 4-8. Connecting The Sdlt 600 Fibre Channel Cable - Tandberg Data SDLT 600 Product Manual

Configuring and Installing a Tabletop Tape Drive

4.5.5

Connect the Fibre Channel Cable

1. Fibre Channel cables are "hot-swappable"—meaning you may connect and disconnect them with
unit power on. Therefore, unlike other systems, the tape drive and computer may remain on to
connect the SDLT 600 tape drive to the host computer.
Insert the fiber optic cable into the Fibre Channel port on the back of the tape drive as shown in
2.
Figure

Figure 4-8. Connecting the SDLT 600 Fibre Channel Cable

4.6 Configuring and Installing a Tabletop Tape
Drive
This section provides instructions for configuring and installing the tabletop model of the SDLT 600
tape drive.
N
OTE
4-20
4-8. The connector is fully seated when it snaps into the port.
: The tabletop model comes ONLY with the SCSI interface. The Fibre
Channel interface is not available.
SDLT 600
Tape Drive
March 2004
SDLT 600 Product Manual
Fibre Channel
Cable
81-81184-02 REV A01