Current And Power Requirements - Tandberg Data SDLT 600 Product Manual

SDLT 600 Product Manual
3.2.3

Current and Power Requirements

Table 3-16 on page 3-12
tape drive system (internal and tabletop) configured with the SCSI interface.
lists the current and power requirements for the internal version of the SDLT 600 tape drive system
configured with the Fibre Channel interface. The library version of the SDLT 600 tape drive uses the
same amount of power as the internal version with both the SCSI and Fibre Channel interfaces. The
tabletop version requires AC power.
The tape drive draws the highest current (and power) during the native write modes. Standby is
measured with the tape loaded and tensioned or untensioned, and Idle is measured with power on with
no tape loaded. (The power drawn in these two modes is similar enough that they are listed together.)
N
OTE
81-81184-02 REV A01
lists the current and power requirements for the two versions of the SDLT 600
: In Table 3-16 and Table
the internal tape drive, while the AC power values apply to the tabletop
tape drive.
3-17, the current and DC power values pertain to
March 2004
Chapter 3: SDLT 600 Tape Drive Specifications
Table 3-17 on page 3-13
3-11