Fibre Channel Interface; Physical Interface; Table 3-2. Sdlt 600 Tape Drive Interfaces; Sdlt 600 Tape Drive Specifications - Tandberg Data SDLT 600 Product Manual

SDLT 600 Product Manual
In SE mode, the SCSI bus can support up to 7 devices using cable lengths up to 3 meters. In LVD
mode, the SCSI bus can support up to 15 devices using cable lengths up to 25 meters.
For more information about the SCSI interface, refer to the SDLT 600 SCSI Interface Guide
(81-81200-01).

Fibre Channel Interface

The Fibre Channel interface runs at speeds up to either 1 Gb/second or 2 Gb/second, depending on the
configuration you choose during installation.
Fibre Channel can support up to 126 devices in a loop configuration. Longwave transceivers (with
fiber optic cable) support distances up to 10 kilometers; shortwave transceivers (with fiber optic cable)
support distances up to 500 meters.
For more information about the Fibre Channel interface, refer to the SDLT 600 Fibre Channel
Interface Guide (81-81202-01).
3.1.2

Physical Interface

The SDLT 600 tape drive has the interfaces shown in
type, per port).

Table 3-2. SDLT 600 Tape Drive Interfaces

Interface Versions
Fibre Channel
Parallel SCSI
81-81184-02 REV A01
Physical Characteristics
Topology-constrained (force point-to-point)
1 Gbit or 2 Gbit interface (selectable at time of installation)
850 nanometer LC connector transceiver (optional)
MSE, LVD
Ultra 160
SCSI ID (user selectable at time of installation)
TERMPWR connector style: 4-pin
Connector style: 68-pin high density SCSI
March 2004
Chapter 3: SDLT 600 Tape Drive Specifications
Table 3-2 available from the back panel (per
3-3