Table of Contents
Advertisement
SDLT 600 Product Manual
The tabletop unit power supply has an auto-sensing feature; it requires no adjustment or switch setting
changes for different AC sources.
Refer to
Figure 4-9
back of the tabletop tape drive; connect the other end of the cord to the AC outlet. Upon completion,
proceed to the next section to confirm the installation.
4.7
Confirming the Installation
To confirm the installation, power on the SDLT 600 tape drive system and the host computer. The
screens displayed at power-on contain BIOS, operating system, and SCSI controller information. If the
first screen displays host adapter and SCSI ID information, then the installation is successful. Refer to
"Troubleshooting" on page 5-12
81-81184-02 REV A01
and
Figure
4-12. Connect one end of the AC cord into the power connector on the
if the installation is not successful.
March 2004
Chapter 4: Installing Your Tape Drive
4-25
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SDLT 600 and is the answer not in the manual?
Questions and answers