Table of Contents
Advertisement
Call Handling
Ending an Ongoing Call
Ending a Point-to-Point Call
Use either of the below methods:
•
Press the End
) on the remote control.
Call button (
•
Presets
Press the OK/Menu button on the remote control to display the menu.
This will produce the End
Call dialogue box:
Snapshot
Touch tones
Use either of the below methods:
•
Press the End
Call button (
) on the remote control again.
•
Presets
Press the OK/Menu button to confirm that the call is to be ended.
Switching off the monitor(s), using the
Tip!
Snapshot
Touch tones
power button on the monitor, will not end a
call. Some systems even come with moni-
tors that cannot be switched off!
D 13954.01
JUNE 2006
Use either of the below methods:
•
Press the End
Call button (
•
Presets
Press the OK/Menu button on the remote control to display the menu.
This will produce the End
Call dialogue box:
Snapshot
Touch tones
Use either of the below methods:
•
Press the End
Call button (
•
Presets
Press the OK/Menu button to confirm that the call is to be ended.
Ending a MultiSite call can only be
Tip!
Snapshot
Touch tones
done by the host. The other parties can
disconnect themselves from the conference
at any time, but they have no influence on
the rest of the conference.
3
Ending a MultiSite Call
) on the remote control.
) on the remote control again.
To end one or a few of the calls in a
Tip!
MultiSite Meeting navigate to the name of
the call to be terminated and terminate the
call as if it were a point-to-point call.
TANDBERG 1700
MXP
USER GUIDE
Advertisement
Table of Contents
