Ending An Ongoing Call; Ending Multisite Calls - TANDBERG MXP User Manual

MXP Video endpoints
What's in this user guide?

Ending an ongoing call

You end an ongoing call in the same way as you
do when using a mobile phone by pressing the
red End Call key on the remote control. This will
produce the Call menu.
Switching off the monitor(s) using the power
on/off switch on the monitor will not end an
ongoing call. Some systems even come with
monitors that cannot be switched off!
D14034.04—MAY 2008
Getting started Making calls
Ending an ongoing point-to–point call...
Press the End Call key or the OK key on the
remote control...
This will cause the End Call dialog box to be
displayed...
Then press the End Call key or the OK key on
the remote control again...
Phone book usage Video meeting features
Ending an ongoing MultiSite call...
Press the End Call key or the OK key on the
remote control...
This will cause the End Call dialog box to be
displayed...
Then press the End Call key or the OK key on
the remote control again...
User Guide
Video conferencing features

Ending MultiSite calls

Ending a MultiSite call can only be done by the
host. The host is the party that initiated the video
conference.
The other parties can disconnect themselves
from the conference at any time, but they have no
influence on the rest of the conference.
To end one or a few of the calls in a MultiSite video
conference, navigate to the name of the call to be
terminated and terminate that specific connection
as if it were a simple point-to-point call.
20