H.323 Settings (Ii) - Gatekeeper Settings - TANDBERG 1700 MXP User Manual

Control Panel > Network Settings > LAN Settings
H.323 Settings (II) – Gatekeeper Settings
Camera Presets
Snapshot Touch tones
D 13954.01
MAY 2006
Auto. The system will automatically try to register to any
available gatekeeper. If a gatekeeper responds to the
request sent from the codec within 30 seconds this
specific gatekeeper will be used. This requires auto
discovery on the gatekeeper as well. If no gatekeeper
responds, the system will not use a gatekeeper for
making H.323 calls and hence an IP-address must be
Manual. The system will use a specific gatekeeper
Camera Presets
Snapshot Touch tones
The rest of the lower part of the menu is
explained on the following pages.
CANCEL
Select this icon and press OK
to leave the menu undoing any
changes.
RESTORE DEFAULTS
Select this icon and press OK
to restore the default settings.
SAVE
Select this icon and press
OK to leave the menu putting
changes into effect.
113
GATEKEEPER DISCOVERY
specified manually.
identified by Gatekeeper IP-address.
Camera Presets
Snapshot Touch tones
TIP! if your system is part of a TANDBERG Expressway™
firewall traversal solution and is placed outside the fire-
wall, you should register the IP address of your Border
Controller as the Gatekeeper IP address and set H.323
Call Setup to Gatekeeper.
TANDBERG 1700 MXP
USER GUIDE
GATEKEEPER IP ADDRESS
This is the gatekeeper IP-ad-
dress that is used if you specify
H.323 Call Setup: Gatekeeper
and Gatekeeper Discovery:
Manual.
AUTHENTICATION MODE
Auto. If Authentication Mode
is set to Auto and the gate-
keeper indicates that it requires
authentication, the endpoint will
automatically try to authenticate
itself to the Gatekeeper.
Off. If Authentication Mode is
set to Off the system will not try
to authenticate itself to a Gate-
keeper, but will still try a normal
registration.
AUTHENTICATION ID /
AUTHENTICATION PASSWORD
The system sends the Authen-
tication ID and Password to a
Gatekeeper for authentication.
The authentication is a one way
authentication from the endpoint
system to a Gatekeeper, i.e. the
endpoint is authenticated to the
Gatekeeper. If the Gatekeeper
indicates that no authentication
is required, the endpoint will still
try to register.