Call Handling
Making Point-to-Point Video & Telephone Calls Manually
Select Make a
Call from the menu,
or, press the green Call key on the remote control.
The TANDBERG system can make both Video calls and
Telephone calls. Telephone calls over IP may require
additional hardware and infrastructure. If in doubt contact
your administrator or your TANDBERG representative.
Do one of three things:
• Place the call by pressing OK so that the Place
• Use the Arrow keys on the remote control to select the Place
• Press the green Call key on the remote control.
Snapshot
Making Telephone Calls Manually
Do as described above for a video call, but make sure
Telephone
Call is selected.
D 13954.01
JUNE 2006
Make sure Video
see below for details.
Presets
Call icon is selected and press OK once again
Call icon and press OK
Touch tones
Making Video Calls Manually
Call is selected (as shown here). If not,
2
Enter the dial number manually using the Numerical
Keypad.
When dialling manually, observe the guidelines given in
Numerical Keypad Features. Use
*
addresses. If a system is registered on a gatekeeper or
border controller with DNS support, there are several
ways to call into the system:
•
<IP address>
•
<E.164>
•
<H.323 ID>
•
<H.323 ID>@<domain>
•
<E.164>@<domain>
See H.323 Settings for details
Choosing Between Video and Telephone Call
Use the Arrow keys, navigate
to the Call
Type icon, and click
OK. Select the type of call and
click OK to exit the submenu.
TANDBERG 1700
MXP
USER GUIDE
as separator in IP