Ending An Ongoing Call; Ending Conference Calls; Ending Point-To-Point Calls; Ending Multisite Calls - TANDBERG MXP User Manual

What's in this guide?

Ending an ongoing call

Y
ou end an ongoing call in the same
way as you do when using a mobile
phone— by pressing the red End Call
key on the remote control. This will
produce the Call menu.
Note! Switching off the monitor(s)
using the power on/off switch on
the monitor will not end an ongoing
call. Some systems even come with
monitors that cannot be switched off!

Ending conference calls

Ending a MultiSite call can only be done
by the host. The host is the party that
initiated the video conference.
The other parties can disconnect
themselves from the conference at any
time, but they have no influence on the
rest of the conference.
To end one or a few of the calls in a
MultiSite video conference, navigate to
the name of the call to be terminated
and terminate that specific connection
as if it were a simple point-to-point call.
D1403405 USER GUIDE VIDEO ENDPOINTS MXP ENGLISH—SEPTEMBER 2009
Getting started Making calls Making calls Using the phone book
Ending point-to–point calls
Press the End Call key or the OK key on
the remote control...
This will cause the End Call dialog box
to be displayed...
Then press the End Call key or the OK
key on the remote control again...
21
In-call features Video conferencing

Ending MultiSite calls

Press the End Call key or the OK key on
the remote control...
This will cause the End Call dialog box
to be displayed...
Then press the End Call key or the OK
key on the remote control again...