Table of Contents
Advertisement
Getting Acquainted with the System
Standby
About Standby
The system will automatically go to Standby
Mode when it is not in use. In Standby
Mode, the screen(s) will turn black. It is,
however, still possible to receive incoming
calls.
The Standby Mode of the system should be
enabled if the system is to be left idle.
Leaving Standby Mode
When the system is in Standby, pick up the
remote control, or press any of its keys to
activate the system again.
Note! Standby is not activated by switch-
ing off the power to the monitor(s) (some
systems come with monitors that are not
possible to switch off.).
Tip! If the system is set for Use screen as Local
PC
monitor, see Control Panel > Screen Set-
tings, the Standby mode will be disabled when
the codec detects a video signal from the
PC. When the PC video signal no longer is de-
tected, the standby mode will be re-enabled.
D 13954.01
JUNE 2006
Press OK and navigate to the
Standby icon. Select Standby from
the menu and click OK.
Press OK/Menu and navigate to the
Standby icon. Select Standby from
the menu and click OK.
Press OK/Menu and navigate to the
Standby icon. Select Standby from
the menu and click OK.
To Enable Immediate Standby Mode
Navigate to the Standby
now icon
and click OK.
To Enable Delay Standby Mode for 1 Hour
Navigate to the Delay Standby for 1
hour icon and click OK.
To Enable Delay Standby Mode for 3 Hours
Navigate to the Delay Standby for 3
hours icon and click OK.
23
TANDBERG 1700
USER GUIDE
The system will now enter Standby
Mode immediately.
The system will enter Standby
Mode
in 1 hour from now.
The system will enter Standby
Mode
in 3 hours from now.
MXP
Advertisement
Table of Contents
