Table of Contents
Advertisement
Control Panel > Network Settings > LAN Settings
Wireless LAN Settings
Camera Presets
Snapshot
Touch tones
D 13954.01
MAY 2006
Camera Presets
Snapshot
Touch tones
Camera Presets
ENCRYPTION
Select Encryption if you want to use WEP encryption on
Snapshot
Touch tones
your Wireless LAN connection. Increased encryption level
will decrease performance.
USE KEY
Select which of the keys shown below you want to use.
KEY 1-
The 64-bit keys can consist of a leading star (*) and
5 characters.
The 128-bit key can consist of a leading star (*) and 13
characters. Start with a * and then the text. Example:
128 bit
key: *secretkeyhome.
Encryption using Hex
numbers The 64-bit keys can consist
of 10 hexadecimal digits. Example: "de01ad4dbe". The
128-bit key can consist of 26 hex numbers.
118
TANDBERG 1700
SSID (Service Set Identification)
Example "WLANNETWORK". Defines a local
network id for this wireless region. It must be the
same for all end points and the access point. An
endpoint will find the access point if the SSID is
correct, however if the encryption key is faulty it
will not transmit any data.
COMMUNITY (optional)
Community can be used when connecting to
an access point where the SSID is the same.
Example
"Unit2".
WLAN MODE
AdHoc. Used when not communicating with an
access point.
Managed. Used when communication is made
through an access point.
Make sure the corresponding settings are pro-
grammed into the access point. Press Restart
from Control Panel
in order to activate the set-
tings.
REQUIRED CARDS
•
Compaq WL110 11 Mbps Wireless LAN
•
Lucent Orinoco 11 Mbit/s SILVER
•
Lucent Orinoco 11 Mbit/s GOLD
•
Cisco Aironet 350 series (AIR-PCM 350
series)
•
Enterasys Networks RoamAbout 802.11 DS
High Rate
•
Melco Buffalo WLI-PCM-L11G
RECOMMENDED ACCESS POINT
•
Compaq WL410 base station
NOTE! The PC card/PCMCIA-card used must comply
with the relevant regulations for such cards in the
country where it is used. The unit must be supplied
by power supply (AC-DC adaptor) powerbox SPN-
270-12, which complies with the requirements for
limited power source according to IEC/EN 60950.
MXP
USER GUIDE
Advertisement
Table of Contents
