1.
Plug the RJ45 connector into the data port on the scanner.
2.
Plug the PS/2 connector into the PS/2 port on the host device.
3.
Plug the supplied power adapter into the power jack on the PS/2 cable,when desired.
4.
Plug the common keyboard adapter into the RS-232 port on the host device,when desired.
Connect the NVH300-DP Communication Data Cable
Connect the Communication cable to NVH300-DP, the specific operation steps are as follows:
1. Counterclockwise unscrew ① at the slot of the data line ;
2. Move the cable sheet ② in the direction shown by the arrow on the left, and open the chuck;
3. After inserting the data line into the slot, move the cable sheet ② in the direction shown by the arrow on the right.
4. Rotate the screw ①clockwise and lock the chuck.
Remove theNVH300-DP Communication Data Cable
When you need to remove the cable from NVH300,The specific operation steps are as follows:
1. Counterclockwise unscrew ① at the slot of the data line ;
11