Chapter 10 Batch Programming; Introduction - Newland NLS-NVH300 Series User Manual

Chapter 10 Batch Programming

Introduction

Batch programming enables users to integrate a batch of commands into a single batch barcode.
Listed below are batch programming rules:
1. Command format: Command + Parameter Value.
2. Each command is terminated by a semicolon (;). Note that there is no space between a command and its terminator
semicolon.
3. Use the barcode generator software to generate a 2D batch barcode.
Example: Create a batch barcode for Illumination On, Sense Mode, Decode Session Timeout = 2s:
1. Input the commands:
@ILLSCN1;SCNMOD2;ORTSET2000;
2. Generate a batch barcode.
When setting up a scanner with the above configuration, scan the Enable Batch Barcode barcode and then the batch
barcode generated.
@BATCHS
Enable Batch Barcode
280