Using Ps/2 Cable; Removing Communication Cable - Newland NLS-HR22 User Manual

Enter Setup

Using PS/2 Cable

Connect the scanner to a Host through a PS/2 cable with RJ45 and PS/2 connectors and a power jack:
1. Plug the RJ45 connector into the data slot on the scanner.
2. Plug the PS/2 connector into the PS/2 port on the Host.
3. When required, plug the power adapter into the power jack on the PS/2 cable.
4. When required, connect the PS/2 cable to a keyboard via its PS/2 port.

Removing Communication Cable

Get an appropriate needle or a straightened paper clip and then follow the steps below:
1. Disconnect the power adaptor from mains if there is one.
2. Insert the needle into the hole.
3. Pull out the cable slowly from the scanner while pressing the needle in.
4. Remove the needle.
5. Disconnect the cable from the Host.
** Exit Setup 6