Reread Timeout
Reread Timeout can avoid undesired rereading of same barcode in a given period of time. This feature is only applicable to
Continuous modes.
Enable Reread Timeout: Do not allow the scanner to reread same barcode before the reread timeout expires.
Disable Reread Timeout: Allow the scanner to reread same barcode.
@RRDENA1
** Enable Timeout between Decodes
The following parameter sets the time interval between two successive reads on same barcode. It is programmable in 1ms
increments from 1ms to 3,600,000ms. The default setting is 15,000ms.
Set the reread timeout to 1,000ms:
1. Scan the Set Reread Timeout barcode.
2. Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
3. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
35
@RRDDUR
Set Reread Timeout
@RRDENA0
Disable Timeout between Decodes