Table of Contents
Advertisement
2.3.3).
Caution:
Make sure the print method:
If selecting thermal transfer printing, the ribbon needs to be installed;
If selecting thermal printing, there is no need to install ribbon.
Under normal condition, the width of ribbon selected should be wider than that of print
medium;
During the process of installing the ribbon, avoid the wrinkle or damage of ribbon.
2.4 Power adapter connection
1) Ensure the printer is turned off;
2) Connect one end of the AC power input cable to power adapter, and then insert the other
end of the power adapter into the power adapter interface on the back of printer;
3) Insert the other end of AC power input cable into the 220V power socket.
Caution:
If leaving the printer idle for a long time, please disconnect the power of printer.
2.5 Communication cable connection
1) Ensure the printer is turned off;
2) Insert the communication cable into the suitable interface, and fix it with screw or latch
spring of the plug;
3) Connect the other end of the communication cable to the host.
Caution:
Don't connect or disconnect the serial/parallel communication cable when the power has
not been turned off.
2.6 Start the printer
2.6.1 Power-on and self-test
1) Ensure the power adapter and the communication cable are connected correctly, and turn on
the printer;
2) The printer starts the self-test. The buzzer beeps once for a short time after the self-test is
finished, and then the LED displays green and it is always on;
3) If power-on action is set, the printer will perform power-on action.
Note: Power-on action refers to the actions performed automatically after the printer is turned on,
including feeding one label, starting calibration automatically (only valid under
discontinuous paper mode). The power-on action can be set by commands or
configuration tools.
Caution:
If the printer can not be started or can not work normally after it is started, please contact
Newland or local dealer in time.
- 7 -
Advertisement
Table of Contents
