Change Data Format for a Single Scan
You can switch between data formats for a single scan. The next barcode is scanned using the data format selected here,
then reverts to the format you have selected above. For example, you may have set your scanner to the data format you
saved as Format_3. You can switch to Format_1 for a single trigger pull by scanning the Single Scan – Format_1 barcode
below. The next barcode that is scanned uses Format_1, then reverts back to Format_3.
Note: This setting will be lostby removing power from the scanner, or turning off/ rebooting the device.
@DFMSIN0
Single Scan – Format_0
@DFMSIN2
Single Scan – Format_2
247
@DFMSIN1
Single Scan – Format_1
@DFMSIN3
Single Scan – Format_3