Removing The Cable Of Nvh300-Hd; Power On, Power Off, Reboot - Newland NLS-NVH300 Series User Manual

2. Move the cable sheet ② in the direction shown by the arrow on the left, and open the chuck;
3. Gently pull out the end of the data line connected with the scanner and move the cable sheet toward the direction
shown by the arrow in the right picture.
4. Rotate the screw ① clockwise and lock the chuck.

Removing the Cable of NVH300-HD

Get an appropriate needle or a straightened paper clip and then follow the steps below:
1. Disconnect the power adapter from mains if there is one.
2. Insert the needle into the hole.
3. Pull out the cable slowly from the scanner while pressing the needle in.
4. Remove the needle.
5. Disconnect the cable from the host device.

Power On, Power Off, Reboot

Power on the scanner
Connect the scanner to a host device. Then the scanner will be turned on and automatically enter the sleep mode.
Power off the scanner
Remove the cable from the scanner; or remove the cable from the host device; or disconnect the power adapter from
mains.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, turn off the scanner and then turn it back on.
12