Installing And Removing Hard Drives - Supero FatTwin F517H6-FT User Manual

6-6

Installing and Removing Hard Drives

The F414IS chassis contains individual motherboards in separate 1U nodes. Each
motherboard node controls the hard drives contained within that node. Note that if
a node is pulled out of the chassis, the hard drives associated with that node will
power down as well. Refer to the charts below and on the following pages for your
specifi c chassis confi guration. These instructions apply to fi xed 3.5" hard drives.
Only enterprise level hard drives are recommended for use in Supermicro chassis.
Figure 6-3: Chassis Nodes and their Corresponding Motherboards
(Your chassis and drives may differ from those shown in this illustration)
F414IS-R1K62B Chassis Nodes and Their Hard Drives
Controls twelve (12) 3.5" HDDs, and two (2) 2.5" HDDs, D1-D15
Controls twelve (12) 3.5" HDDs, and two (2) 2.5" HDDs, C1-C15
Controls twelve (12) 3.5" HDDs, and two (2) 2.5" HDDs, B1-B15
Controls twelve (12) 3.5" HDDs, and two (2) 2.5" HDDs, A1-A15
Chapter 6: Advanced Chassis Setup
Node 4
Node 3
Node 2
Node 1
6-5