Power Adapter Board Replacement - Supero FatTwin F517H6-FT User Manual

FatTwin F517H6-FT USER'S MANUAL
6-9

Power Adapter Board Replacement

Each of the nodes includes a power adapter board, which connects it to the chassis.
In the unlikely event of a failure of the power adapter board, replacement is simple
and requires only a Phillips head screwdriver.
Changing the Power Adapter Board
1. Power down the node with the operating system and remove the cord from
the rear of the power supply as described in Section 6-3. Remove the node
from the chassis as described in Section 6-4. Remove the node cover as
described in Section 6-5.
2. Remove the screws securing the power adapter board to the fl oor of the node
and set them aside for later use.
3. Lift the power adapter board up and out of the node.
4. Place the power adapter board into the same position on the fl oor of the
node, aligning the mounting holes of the board with those in the node. Secure
the board with the screws previously set aside. Do not exceed eight pound of
torque when tightening the power distributor board.
5. Place the cover back on the node, return the node to the chassis, plug the
power cord into the rear of the power supply and power up the node.
Figure 6-9: Removing the Power Adapter Board
1
3
1
2
6-10