Installing Memory - Supero FatTwin F517H6-FT User Manual

FatTwin F517H6-FT USER'S MANUAL
5-5

Installing Memory

Caution: exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
Installing Memory
1. Insert the desired number of DIMMs into the memory slots, in the following
order: DIMMB1 (blue slot), DIMMB2 (blue slot), DIMMA1 and DIMMA2. (For
best performance, please use the memory modules of the same type and
speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Reverse the steps above to remove the DIMM modules from the motherboard.
Note: 1 GB, 2 GB, 4 GB or 8 GB size memory modules are supported. It is highly
recommended that you remove the power cord from the system before installing or
changing memory modules. Please refer to our web site for memory that has been
tested on the X9SCFF-F serverboard.
To Install: Insert
module vertically and
press down until it
snaps into place.
Pay attention to the
alignment notch at
the bottom.
To Remove: Use
your thumbs to gently
push the release tabs
near both ends of the
module. This should
release it from the
slot.
Figure 5-2. Installing DIMM into Slot
Notch
Release Tab
5-10
Front View
Note: Notch should align with
the receptive key point on
the slot.
Top View of DDR3 Slot
Notch
Release Tab