6-13 Replacing The Power Supply; Power Supply Replacement - Supero FatTwin F517H6-FT User Manual

FatTwin F517H6-FT USER'S MANUAL

6-13 Replacing the Power Supply

The F414IS chassis includes two 1620 Watt power supplies that are auto-switching
capable. This enables it to automatically sense and operate at a 100v to 240v input
voltage. An amber light will be illuminated on the power supply when the power is
off. An illuminated green light indicates that the power supply is operating.

Power Supply Replacement

The F414IS chassis utilizes two redundant power supplies. In the unlikely event that
the power supply unit needs to be replaced, one power supply can be removed,
without powering down the system. Replacement units can be ordered directly from
Supermicro (See the contact information in the Preface of this manual).
Changing the Power Supply
1. Power down the system and disconnect the AC power cord on the back of the
failed power supply.
2. Press the release tab on the back of the power supply and pull the power
supply out using the handle provided.
3. Push the replacement power supply module into the power bay until it clicks
into the locked position.
4. Plug the AC power cord back into the module and return the node to its bay
in the chassis..
Figure 6-15: Changing the Power Supply
6-18
Release Tab