Supero FatTwin F517H6-FT User Manual page 111

RAID Mode
The following items are displayed when RAID Mode is selected:
PCH RAID CodeBase
Select Intel to enable the Intel SATA Host RAID Utility. Select LSI to use the
LSI Host RAID Utility. The options are Intel and LSI.
Serial ATA Port0~Port5
This item displays the information detected on the installed SATA drives on
the particular SATA port.
Hot Plug
Set this item to Enabled to enable hot-plugging. The options are Enabled
and Disabled.
 PCI-E/PCI/PnP Confi guration
This feature allows the user to set the PCI/PnP confi gurations for the following items:
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128,
160, 192, 224 and 248.
Above 4G Decoding
This option is available if your system supports 64-bit PCI decoding. Select Enabled
to decode a PCI device that supports 64-bit in the space above 4G Address. The
options are Enabled and Disabled.
PERR# Generation
Select Enabled to allow a PCI device to generate a PERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
SERR# Generation
Select Enabled to allow a PCI device to generate an SERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
Launch Storage OpROM Priority
Use this feature to select the Option ROM to boot the system when there are multiple
UEFI and Legacy storage Option ROMs available in the system. The options are
Do not launch, UEFI only, Legacy only, Legacy fi rst, and UEFI fi rst.
7-11
Chapter 7: BIOS