Supero FatTwin F517H6-FT User Manual page 65

Notes:
1. For the latest CPU/Memory updates, please refer to our website at
www.supermicro.com/products/motherboard/
2. Use only the correct type of onboard CMOS battery as specifi ed by the
manufacturer. Do not install the onboard battery upside down to avoid
possible explosion.
3. Jumpers not indicated are for test purposes only.
4. All graphics shown in this manual were based upon the latest PCB Revision
available at the time of publishing of the manual. The motherboard you've
received may or may not look exactly the same as the graphics shown in this
manual.
Jumper
Description
JBT1 Clear CMOS
PCI Slot SMB Enable
JI2C1,JI2C2
JPB1 BMC Enable/Disable
JPG1 VGA Enable/Disable
JPME2 ME Manufacturing Mode
JPME1 ME Recovery
JPL1 LAN1 Enable/Disable
JWD1 Watch Dog Timer Reset/NMI
LED Description
LED4 IPMI Heartbeat
LED5 Overheat/Fan Fail/Power Fail
Warning
LED6 Front Panel UID
Chapter 5: Advanced Motherboard Setup
X9SCFF-F Jumpers
Default Setting
Short contact pads to clear CMOS
Short (Enabled), Open (Disabled)
Pins 1-2 (Enabled), 2-3 (Disabled)
Pins 1-2 (Enabled), 2-3 (Disabled)
Pins 1-2 (Normal), 2-3 (Manuf. Mode)
Pins 1-2 (Normal), 2-3 (Recovery Mode)
Pins 1-2 (Enabled), 2-3 (Disabled)
Pins 1-2 (Reset), 2-3 (NMI)
X9SCFF-F LED Indicators
State
Green: Blinking
Red: On, Steady
Red: On, Blinking
Blue: On, Steady
5-13
for details.
Status
IPMI is running
(Normal)
System Overheat
Fan Fail/Power Fail
Unit ID switch is on
http://